Home Products & Services

A Quick Overlook of Services – Your Cheatsheet

Basement Waterproofing; Read the DIY Tips for Your Home Improvement If your basement foundation is poorly constructed, water seepage and condensation may occur when it rains. No one would want to experience such a demoralizing situation, but there is a solution to minimize the condition. Waterproofing is one of the key solutions to reduce this kind of a mess within your basement. First of all; you need to identify an effective waterproofing coating. Given the difficulties of preventing water seeping, the waterproofing will work well if the walls are well constructed. Poorly constructed walls require removal of the loose mortar and broken blocks. Using a wire brush, clean the dirt and grease, plus any other contaminant from the surface. Apply a quick-dry concrete to seal the openings and cracks on the wall. Read the manufacturer’s instructions before you start working on the openings and cracks. Sometimes, the waterproofing is mixed with cement before applying on the cracks. But, avoid the mistake of using inadequate or excessive waterproofing. Using a higher amount of waterproofing is better as it means the cracks are sealed well.
Where To Start with Basements and More
More importantly, avoid making a thin waterproof as it will not stop moisture leakage. If the water is seeping at a higher rate, you can add an extra coating to strengthen the first coating. However, ensure the coating work is done directly on the building material. Make sure all cracks are sealed appropriately.
Lessons Learned from Years with Remodels
When you start shopping for moisture coating products, you need to be a bit careful to buy the right product. You will come across ‘water repellant’ and ‘waterproofing coatings’ and many manufacturers use these terms as substitutions of one another. The two are different things. Water repellant is used for exterior coating above the concrete, and does not really prevent water seepage under hydrostatic pressure. On the other hand, waterproofing coatings are usually used to prevent water passage under hydrostatic pressure. It is particularly applied on and below the concrete on both interior and exterior wall surfaces. Faulty guttering systems, high water table, wind-driven downpour, or surface runoff flowing towards a house are some of the major factors that cause the hydrostatic pressure. It is important for every homeowner to know the difference between a moisture seepage and condensation. To know the root cause of moisture accumulation on the foundation, place an aluminum foil on the foundation wall and leave it for a few days. If you find that the foil’s side in contact with the wall is wet, the possible problem is seepage. If the wetness is on the upper side, there is a condensation problem. However, both condensation and seepage could be a problem if both sides of the foil are wet. Therefore, a dehumidifier and a high-quality waterproofing coating can stop moisture condensation and water seepage respectively.